Method of Medical Mold Grinding


The importance of medical mould grinding
The regular polishing of the mold ensures consistent stamping quality. Polishing the mold regularly can not only increase the service life of the mold, but also increase the service life of the machine tool. Must grasp the correct timing of shar

.
  1. The importance of medical mould grinding
    The regular polishing of the mold ensures consistent stamping quality. Polishing the mold regularly can not only increase the service life of the mold, but also increase the service life of the machine tool. Must grasp the correct timing of sharpening.
    2. The specific characteristics of the mold need to be sharpened
    For the sharpening of the mold, there is no strict number of hammer strokes to determine whether sharpening is required. This mainly depends on the sharpness of the blade. Mainly determined by the following three factors:
    (1) Check the fillet of the cutting edge. If the fillet radius reaches R0.1mm (the maximum R value cannot exceed 0.25 mm), sharpening is required.
    (2) Check the stamping quality. Are there big burrs?
    (3) Determine whether sharpening is required according to the noise of machine punching. If the same pair of molds make abnormal noises during punching, the punch is blunt and needs to be sharpened.
    Note: The edge of the blade is rounded or the back of the blade is rough. Sharpening should also be considered.
    3. Sharpening method
    There are many ways to sharpen the mold. This can be achieved with a special sharpener or on a surface grinder. The sharpening frequency of punch and die is generally 4:1. Please adjust the mold height after sharpening.
    (1) The harm of incorrect sharpening method: Incorrect sharpening will aggravate the rapid damage of the mold blade, resulting in a greatly reduced number of hammer strokes per sharpening.
    (2) The advantages of the correct sharpening method: Regular sharpening of the mold can keep the punching quality and accuracy stable. The blade of the mold is damaged slowly and has a long service life.
    4. Sharpening rules
    The following factors should be considered when grinding the mold:
    (1) In the case of R0.1-0.25 mm, the sharpness of the cutting edge fillet depends on the sharpness of the cutting edge.
    (2) The surface of the grinding wheel should be cleaned.
    (3) It is recommended to use soft coarse-grained grinding wheels. Such as WA46KV
    (4) The grinding amount (tool) should not exceed 0.013 mm each time. Excessive grinding will cause the mold surface to overheat, which is equivalent to annealing treatment, the mold becomes soft, and the mold life is greatly reduced.
    (5) Sufficient coolant must be added when grinding.
    (6) When grinding, the punch and the lower die should be firmly fixed and special fixtures should be used.
    (7) The grinding volume of the mold is constant. If this value is reached, the punch will be scrapped. If you continue to use it, it is easy to damage the mold and the machine.
    (8) After polishing, the edges should be treated with a sharpening stone to remove excessively sharp edges.
    (9) After sharpening, clean, demagnetize and oil.

If you have interests about Zhengri Syringe Assembly Machine , welcome to send us messages.